SOME IMPORTANT SUGGESTIONS TO PLASTIDIP A CAR

Plastidip your car as it can direct you towards maintaining your vehicle. It is a cheap method and provides best quality results. Here are some steps to plasti dip an automobile:
Firstly, you’ll need a large area which is wholly covered so that no sunlight can pass through it. Car garage or shelter is the greatest place for it. Before plasti dipping, wash the vehicle so that all dirt particles wash away. You have to buy plasti dip solution. Plasti dip Belgium products are durable but little bit expensive. Quality never comes cheap so do it. After washing the car, dry it with towel. Avoid paper towels since it would make scratches on the surface of car. After drying, prepare a location where you desire to plasti dip. It removes the irritation of removing over or under sprays. Surface may be prepared by within the windows, screens and side mirrors properly with newspaper.

Afterwards, shake the perfect solution is in the can for any minute. It’s going to mix the solution properly. You can begin by painting or spraying anywhere around the prepared the surface of your car. It may need at least 6 hours to complete the task. During the process of painting, do not touch the plasti dip. While spraying plastidip you need to wear a mask and eyes should remain protected with glasses. Liquid rubber can also be plastidip but it is not used for this purpose.

Lower layer of plasti dip needs to be in form of light dusting because it’s the bonding layer. This layer helps one other layers to stick on the paint. Try to keep the can six or eight inches out of the body with the car. It will require at least Quarter-hour to dry. Quantity of layers on first layer increases the longevity of plasti dip. There should be 4-5 layers of plastidip whereas second and third layers ought to be lighter compared to the first one. Allow 15-30 minutes for that layer to dry before using the next coat.

After layering the car, remove the papers that have been used for covering purpose. It must be removed ahead of the completion of drying process. Plasti dip will take 4 hours to cure or fully choose the surface of one’s car. Throughout the curing process, do not use any liquid on car. You can also spray on grille and emblems. It may be sprayed along the way of spraying the body of car. But when not sprayed at that time, spray it following the curing process. Revise every one of the above steps while spraying grille and emblems. You can even plasti dip rim from the car. Two processes can perform it. One is to open the wheel, separate the rim from this, and then spray it. Other the first is to spray the rim by since the rubber of tires. First technique is the cleanest way while the other one is the easiest of all.

Always use painter’s mask, gloves, eye protection glasses, newspaper, old clothes and water in case of emergency while painting or spraying the car.

plasti dip kopen (plasti dip buy) will take 4 hours to cure or fully settle on the surface of your car. Click here to know more about plasti dip.